Roger Mondial Pistol Disassembly, Part 1

This is another recent gun show purchase, a Roger CO2 BB pistol made by MMM Mondial. The manual is here, and there's another page on it here.

Not a bad looking piece of potmetal.

Removing the grips.

The other side of the grips have hexagonal countersunk nuts.

As does the frame, molded haxagonal recesses for the nuts.

The 4 screws removed. Don't lose those nuts, and it's a good idea to study which screw goes where...

The sight is a lot like the one on the Daisy 200.

The two screws pivot it on the angle for elevation.

There's a phillips head screw on the other side.

Be careful pulling the frame halves apart...I wasn't and parts got unsettled.

Here's the proper relationship of the parts.

Pulling the trigger pushes back the hammer until the sear slips off the pins, at the same time as the trigger raises the BB feed mechanism.

One more screw holds the valve assembly to the frame.

You can never have too many pictures of the spring assemblies...

Ok, no complaints if you can't get it back together.

The hammer and spring.

The long end fits down inside the slot.

The BB feed mechanism slides up in that slot.

The magnet.

A BB held by the magnet. Exciting!
More to come...