Drilling some 5/8" diameter bar.
Reaming 1/2"
Soldered (silver soldered) the two parts together. Notice the large area of solder overun...things shifted a bit while they were red hot and I was poking solder into them.
Cleaned up.
Drilling for the sight post.
Tapping #8-32
Turning down the end of a #8-32 setscrew to make the post.
Facing the end.
Tapping #4-40 for the clamp screw.
Installed.
Another lame cold blue job by yours truly. The upside is that I can now shoot the air rifle and hit what I'm aiming at, which was the whole point of this little exercise...
0 comments:
Post a Comment