The spring ends were rough so I smoothed them out.
Likewise with the top hat and spring guide.
Everything stuffed back in, then I screwed the end cap back on.
I temporarily screwed the pivot bolt back in and mounted it to the frame.
I think this is how the safety goes...
The trigger return spring goes over this piece.
Sear- trigger linkage parts mounted.
And spring in place. But the trigger doesn't look right.
Ahh, so the trigger goes above the safety, as shown. The bent part of the linkage goes into the trigger slot. Then I put the grip frame back on.
Yes, after a bit of searching on the bench I found the tiny circlip for the sight and put it together. The pistol functions and is a good can plinker.
0 comments:
Post a Comment