I removed the "stock frame" from the pistol. It was a bit difficult to remove the screw from inside the trigger guard but it wasn't that tight so I could use a long thin screwdriver to access it.
An interesting detail, the pin aligns the from with the tube.
Tiny spring sits above the safety...
And under the spring, a ball.
The grips removed. Quite similar to the early Crosman 130 grips. I'll have to compare the two at some point.
The conical brass washers are a nice touch.
The sear and trigger spring.
Pushing out the trigger pin.
And pushing out the "trigger relay pin".
Time to note the proper orientation of the spring to the sear.
The "relay bearing" is the tube staked(?) into the sear. No point removing it.
I had to wiggle and rotate the safety while pivoting the trigger to get it out.
The safety.
The trigger lifts out.
More to come...
0 comments:
Post a Comment