Wednesday, May 8, 2013

HW50S Rebuild, Part 1

Yes I’ve been AWOL for a while, but life gets busy (kids, two businesses, several other hobbies) and I haven’t had much luck finding odd/rare and cheap airguns to work on lately. We’ve covered almost all of the common airguns and both Derrick and my airgun want lists consist mostly of unobtainable or expensive rarities.
Derrick managed to find me a suitably inexpensive and rough HW50S .177 caliber spring piston rifle at the Findlay airgun show. He thinks I need more German springers in my life and I agree.
DSC03105
Derrick shipped me the rifle, some extra seals and an extra mainspring.
DSC03107
The slot of the cocking lever is chewed up. I lost the pic, but the buttpad is loose and there's a big wallowed out hole for a rear sling screw that needs fixing as well.

DSC03111
Rust pitting that was improved by horrific scraping by the previous owner.
DSC03112
Thankfully the worst of it will be hidden by the stock.
DSC03114
Just minor pitting, freckles and dings on the top of the tube.
DSC03115
The barrel has a patina. An uneven patina.
DSC03117
It’s a Beeman import.
DSC03120
I always like German rifles.
DSC03121
The Rekord trigger unit.
DSC03123
Spares and the trigger guard.
DSC03124
Put it in the spring compressor.
DSC03126
Unscrewing…
DSC03127
There was no tension on it at all.
DSC03130
That spring looks somewhat canted…
DSC03131
I don’t like the look of the welds but they seem original.
DSC03132
This one is slightly better.
DSC03134
Yes, the spring is that canted.
DSC03137
Derrick had sent a synthetic seal that mounted via dovetail, but clearly this is an older gun. I like leather seals and will probably keep it original.
DSC03139
The seal is in good shape.
DSC03147
Some more pitting and scratches.
DSC03150
The pivot bolt.
DSC03151
I love the nut. The “lock washer” seems to have been scavenged from a coil spring. That will probably get replaced as I don’t think it’s original.
DSC03153
The new spring Derrick sent is longer.
DSC03154
It does have two more coils so I’m unsure if it will fit, but I’ll try it as is. We’ll see.
DSC03158
I formed a piece of aluminum around the tube, I’ll use this as a sanding block as I slowly sand all (most) of the pits out. It won’t be fun and will probably take a long while. I’ll then use a cold blue (probably Oxpho blue, limited testing on the gun showed it worked better than the Van’s blue, for this particular gun).

0 comments:

Post a Comment